Features and Benefits:

• Easily separates hard-to-reach spot welded or bonded panels
• Sharpened on three edges, the sharp end allows for penetration between the panels and both side edges allow for side impact to drive the panels apart without damage
• 90 degrees end for use in hard-to-reach pinchweld areas
• Made from a super tough alloy steel and has a cushioned handle that absorbs the shock
• Will save the technician up to 15 minutes per panel replacement

Right Angle SeamBuster (P/N 20016) has added a 90 degree angle along with a third sharpend edge to our popular SeamBuster which allows the body shop technician to gain easy access to the hard to reach pinchwelds.The Right Angled SeamBuster with three sharpened edges is designed to allow bi-directional hammer use on quarter panels, rockers and any other pinchweld. The sharp end allows for penetration between the panels and the two lower edges allows for side impact to drive the panels apart. It is made from a super tough alloy steel and has a cushioned handle that absorbs the shock.Labor/Material Savings:The Right Angled SeamBuster will save the technician up to 15 minutes per panel replacement..